Removing The Oven Bake & Broil Burners & Ignitors - Whirlpool SELF-CLEANING SLIDE-IN GAS RANGES Manual

WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, electri-
cal shock, or explosion.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Turn off the gas supply and electrical
power to the range.
2. Pull the range out from the cabinet far
enough to easily access the back panel.
3. Open the oven door and remove the oven
racks.
4. Remove the three screws from the com-
ponent cover on the rear panel and re-
move the cover (see Figure 4-6).
Top
Tabs
COMPONENT
COVER
Figure 4-6
REMOVING THE OVEN BAKE AND
BROIL BURNERS & IGNITORS
Rear Panel
Side
Remove Top
& Side Screws
Loosen Bottom Screw
Bottom
Refer to Figure 4-7 and inset #1 for the follow-
ing steps.
5. To remove the broil ignitor:
a) From the back of the oven, disconnect
the two broil ignitor leads from the har-
ness wires.
b) From inside the oven, remove the two
ignitor mounting screws from the
bracket and pull the ignitor leads out
of the access hole.
6. To remove the broil burner:
a) Remove the front and rear screws from
the broil burner mounting brackets and
remove the burner.
b) Remove the two screws from the broil
ignitor bracket and remove the ignitor
from the burner.
Refer to Figure 4-7 and inset #2 for the follow-
ing steps.
7. To remove the bake ignitor:
a) From the back of the oven, disconnect
the bake ignitor leads.
b) From inside the oven, remove the oven
bottom.
c) Remove the four screws from the flame
spreader and remove the spreader.
d) Remove the two screws from the bake
ignitor mounting bracket, pull the two
leads out of the oven access hole, and
remove the old ignitor.
8. To remove the bake burner, remove the
two indicated screws from the rear bake
burner mounting bracket, push the burner
back to unhook the front bracket from the
oven liner slot, and remove the burner.
4-10