Heat & Glo SL-350TRS-D Owner's Manual page 16

Two Elbows
Note: Use SL-D Series
components only.
Note: There MUST be a 25%
reduction in total H when using
fl ex vent except when using the
simple up and out installation
(see Figure 5.3).
WARNING
Fire Risk.
• When using SL-HRC-SS and SL-HRC-ZC-SS
termination caps on top vented fi replaces, a one
foot minimum vertical vent section is required
before installing fi rst elbow.
Figure 5.5
16 Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/07
V Minimum
90º Elbow
1/2 ft.
1-1/2 ft.
2-1/2 ft.
3-1/2 ft.
4-1/2 ft.
H
2
SL-350TRS-D, SL-550TRS-E, SL-750TRS-E
152 mm
457 mm
762 mm
1.1 m
1.4 m 14 ft.
H + H Maximum= 14 ft. (4.3 m)
1 2
V + H + H Maximum= 40 ft. (12.2 m)
1 1 2
H
1
H Maximum
NOT ALLOWED
1 ft. 305 mm
2 ft. 610 mm
4 ft. 1.2 m
6 ft 1.8 m
4.3 m
V
1