Transporting Your Scooter - Shoprider GK9 Owner's Manual

Free wheeling Device
The scooter can be moved manually by moving the free wheeling lever
(as indicated figure #7).
This is located on the rear section of the scooter and is the
Yellow lever.
To free wheel the scooter push the Yellow lever towards the front of the
scooter.
To engage the brake pull the lever towards the back of the scooter.
Warning: Do not sit on the scooter while it is in the free wheel mode
and do not disengage the free wheel device when not on level
ground.
FIGURE #7
6
Doors
Always ensure your speed is set at the SLOWEST setting.
Think in terms of using the power of the Q.T. Scooter to do the work for
you. For doors that open outward, hold the door knob with your right
hand and reverse the Q.T. Scooter as described earlier. Where the door
opens inwards, hold the door knob with your left hand and push your
accelerator lever with your RIGHT thumb.

Transporting Your Scooter

Always ensure your scooter is turned OFF on the steering column.
Remove your basket by pulling it up gently.
Remove your seat by folding the back down and gently pulling up on the
seat lever. When the seat lever is up, pull straight up firmly but slowly
and the seat will lift off.
(As indicated in figure #1.)
Remove the battery pack (Models QT3, QT4) by pulling up and forward on
the battery pack handle to release the Velcro tabs holding the battery pack
in place. We suggest you place your free hand on the seat post to help
support you and make the task easier.
(As indicated in figure #2.)
To split the scooter use the red release lever to release the motor
section and lift up to separate.
(As indicated in figure #3.)
Fold the front tiller down onto the scooter after turning the tiller knob
anti clockwise until the small teeth disengage.
(As indicated in figure #4.)
Lay the tiller down and engage the tiller lock at the front of the scooter
to stop the tiller moving in transit. Always remember to disengage the
tiller lock before using your scooter again.
(As indicated in figure #5.)
The scooter is now ready to be placed in the car.
Once the scooter has been placed in the car the basket and battery
pack can be placed loosely around the main components.
(As indicated in figure #6.)
3