Operations In The Channel Display Screen - RSS M-380 Owner's Manual

AUX channel and MAIN L/R channel operations
Sending the audio signal to a
MATRIX bus
This operation is performed in the AUX SENDS area of the
CHANNEL EDIT section.
fig.ChEdtAux.eps
1.
Press AUX SELECT [1]–[8] to select the send-destination
MATRIX bus.
2.
Use the SEND LEVEL knob to adjust the amount of signal
sent to the MATRIX bus.
You can make fine adjustments by holding down [SHIFT] while
you operate the knob.
You can't use SENDS ON FADER to adjust the send amount to
an MATRIX bus.
By pressing [DISP] you can access the MATRIX SENDS popup
where you can make detailed MATRIX send settings.
For the MAIN L/R channel, use [F7 ( MTX SENDS)] or
[F7 ( AUX SENDS)] to switch the CHANNEL DISPLAY screen
between the MTX SENDS display and the AUX SENDS display.
The target of operations in the CHANNEL EDIT section's AUX
SENDS area will also follow the CHANNEL DISPLAY screen.
For the MAIN L/R channel, operations in the AUX SENDS area
are valid only while the CHANNEL DISPLAY screen is shown.
58
Operations in the CHANNEL
DISPLAY screen
The principal parameters of the MAIN L/R channels and AUX
channels can be operated in the CHANNEL DISPLAY screen.
CHANNEL DISPLAY screen
fig.ScrChMainGuide.eps
1 4
2
3
fig.ScrChAuxGuide.eps
1.
Attenuator
fig.ScrMtxATTGuide.eps
b
a
a. ATT knob
This adjusts the channel's input level in the range of -48 dB–0
dB (6 dB steps).
b. OL (Overload) indicator
This will light red when the output of the attenuator exceeds the
OVER Lev setting specified in the METER SETUP popup (p. 96).
7 9
10
11
5 8
6