Turning The Lcr System On; Changing The Aux Used As Main C - RSS M-380 Owner's Manual

LCR SYSTEM

Turning the LCR SYSTEM on

1.
Make sure that the MAIN level indication shows two MAIN
meters, L and R.
If the MAIN level indication shows three meters L, C, and R,
then the LCR SYSTEM is already turned on. The following steps
will not be necessary.
2.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
fig.ScrSystem_LCR_Off.eps
3.
Move the cursor to the LCR SYSTEM button and press
[ENTER].
The LCR SETUP popup will appear.
fig.ScrLCRSetup_Guide.eps
A
A.AUX select buttons
This button selects the AUX that the LCR SYSTEM will use as
MAIN C.
4.
Use the AUX select buttons to select the AUX that you want
to use as MAIN C, and press [F8 (OK)].
fig.ScrLCRSysConf.eps
A confirmation message will ask you to confirm the operation.
In this example, AUX14 has been selected.
You can press [F7 (CANCEL)] to cancel the operation and close
the popup.
136
5.
Press [F8 (CHANGE)].
The AUX you selected in step 3 will be changed to MAIN C,
and the LCR SYSTEM will turn on.
If you press [F7 (CANCEL)], the operation will be cancelled and
you will return to the LCR SETUP popup.
This operation will initialize the following parameters.
• All parameters of the AUX you selected in step 3
• Sends from CH1–48 and MAIN L/R to the AUX you
selected in step 3 (send point, send level, send switch)

Changing the AUX used as MAIN C

1.
Make sure that the MAIN level indication shows three MAIN
meters, L, C, and R.
If the MAIN level indication shows only the two meters L and
R, then the LCR SYSTEM is turned off. Turn the LCR SYSTEM
on as described in "Turning the LCR SYSTEM on" (p. 136)
2.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
fig.ScrSystem_LCR_On.eps
3.
Move the cursor to the LCR SETUP popup button and press
[ENTER].
fig.ScrLCRSetup.eps
The LCR SETUP popup will appear.