Monitor/Solo; About Monitoring - RSS M-380 Owner's Manual

Monitor/Solo

About monitoring

fig.MonitorFlow.eps
SOLO
L R
MONITOR
SOLO
LEVEL
MONITOR
SELECT
AUX 1 OUT
AUX 16 OUT
MAIN OUT L
MAIN OUT R
MAIN MONO OUT
MATRIX 1 OUT
MATRIX 8 OUT
REC OUT L
REC OUT R
L R
SOLO
Monitoring is a function by which the AUX channel, MATRIX channel, MAIN L/R, or USB memory recorder signal that you select as the monitor
source can be sent from the output jacks or headphone jack. This is used mainly by a mixing engineer to monitor the signals.
The monitor output is split to the MONITOR OUT L/R and PHONES OUT, and the level of these two can be adjusted independently. You can use
the output patchbay to patch MONITOR OUT L/R to any desired output jacks.
Solo is a function by which the channel you select using a [SOLO] button is sent from the MONITOR OUT L/R or PHONES OUT jacks. This is
used to monitor a channel temporarily.
Normally, the monitor signal will be output to MONITOR OUT L/R and PHONES. Solo is enabled when you turn on Solo for a channel; the
signal of the channel for which Solo was turned on will be automatically sent to the Monitor output.
Operations in the MONITOR section
The top panel MONITOR section is used to perform Monitor/Solo operations.
fig.MonitorSectGuide.eps
A
B
C
A. LEVEL knob
This adjusts the monitor output level in a range of -Inf dB–+10.0 dB.
B.
DISP button
This accesses the MONITOR screen, where you can make monitor and solo settings.
C.
SOLO CLEAR button
This turns off the solo settings of all channels.
It will blink if any channels are currently being soloed.
122
MONITOR
LEVEL
SOLO MONITOR
LOGIC LEVEL
MONITOR OUT L
MONITOR OUT R
OUTPUT
PATCHBAY
PHONES
LEVEL
D/A
PHONES
OUT