RSS M-380 Owner's Manual page 229

LO-MID Q
Steepness of the frequency response curve at the Lo-Mid band center
frequency (*1)
Value: 0.36–16.00
HI-MID TYPE
Filter type for the Hi-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2, BPF,
BEF, THRU
HI-MID GAIN
Gain of the Hi-Mid band (*1)
Value: -15.0–+15.0 dB
HI-MID FREQ
Center frequency of the Hi-Mid band (*1)
Value: 20 Hz–20.00 kHz
HI-MID Q
Steepness of the frequency response curve at the Hi-Mid band center
frequency (*1)
Value: 0.36–16.00
HI TYPE
Filter type for the Hi band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2, BPF,
BEF, THRU
HI GAIN
Gain of the Hi band (*1)
Value: -15.0–+15.0 dB
HI FREQ
Center frequency of the Hi band (*1)
Value: 20 Hz–20.00 kHz
HI Q
Steepness of the frequency response curve at the Hi band center
frequency (*1)
Value: 0.36–16.00
(*1) Depending on the Type setting of each band, there are certain
combinations for which the Freq, Gain, and Q values will have no
effect, as listed below.
PEAK (Peaking)
Creates a hill or valley in the region of FREQ.
Freq: Valid Gain: Valid
LSV (Low Shelving)
Boosts/cuts the region below FREQ
Freq: Valid Gain: Valid
Q: Valid
Q:-
HSV (High Shelving)
Boosts/cuts the region above FREQ
Freq: Valid Gain: Valid
LPF1 (Low-Pass Filter 1)
Passes the frequency region below FREQ
Freq: Valid Gain:-
HPF1 (High-Pass Filter 1)
Passes the frequency region above FREQ
Freq: Valid Gain:-
LPF2 (Low-Pass Filter 2)
A sharper response curve than LPF1
Freq: Valid Gain:-
HPF2 (High-Pass Filter 2)
A sharper response curve than HPF1
Freq: Valid Gain:-
BPF (Band Pass Filter)
Passes the frequency region around FREQ.
Freq: Valid Gain:-
BEF (Band Eliminate Filter)
Removes the frequency region around FREQ
Freq: Valid Gain:-
THRU (Thru)
Passes all frequency regions
Freq:- Gain:-
Delay A/B
DELAY UNIT
Specifies the units for delay
Value: msec, Meter, Feet, Frame (24, 25, 29.97, 30), Note)
DELAY SW (Delay switch)
Turns the delay on/off
Value: OFF, ON
TIME
Time between the original sound and when the delay is heard
Value: 0.0–1350 ms
FB (Feedback)
Amount of delayed sound returned to the input of the delay.
The feedback level specifies the amount of sound that is returned.
Increasing this setting will increase the number of delay repetitions.
Value: 0–100
LO FREQ DAMP GAIN
Low-frequency attenuation of the delay sound
Value: -36.0–0.0 dB
Appendix
Q:-
Q:-
Q:-
Q: Valid
Q: Valid
Q: Valid
Q: Valid
Q:-
229