8.4.4.5 Set The Execution Delay For A 'Deblank Image Output; Lamp Link Mode - Barco DP2K Series User Manual

8. Macro editor

8.4.4.5 Set the execution delay for a 'deblank image output'

How to set
1. Tip on Deblank Image Output. (image 8-35)
The right pane shows the execution delay input field. The value is expressed in milliseconds.
2. Tip on the up down control of the spin box to change the value. The value change in steps of 10.
Or,
tip in the input field and enter the desired value with the keyboard.
Image 8-35
Deblank image command
8.4.4.6

Lamp link mode

What can be done
The projector can be set as master and the target CLO value can for the slaves can be selected.
How to set up
1. Tip on Lamp link mode. (image 8-36)
2. To set the projector as master, check the check box next to Is master projector.
3. To set the Target footlambert value, tip on the up down control of the spin box until the desired value is
obtained
Or,
tip inside the input box and enter a new value with keyboard.
Image 8-36
Lamp link mode
268 R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012