5.5
Lamp recovery
About lamp recovery
When there was an external power failure and the power is coming up again, the projector lamp starts up
again in the same state as before the power failure.
The projector software has to know if the projector must remember its recovery settings.
About the use of an UPS system
When the projector is connected to an UPS system the electronics remains powered during an external
power failure. The lamp power supply is down and the lamp is out. When the external power is coming
up again, the lamp power supply starts again and the lamp starts in the same state as before the power
failure.
This UPS system reduces the restart of the complete system significantly.
How to setup
1. While in Installation, tip Lamp and then tip Lamp recovery button (1). (image 5-16)
The Lamp recovery window opens (2).
2. To activate the lamp recovery mode, tip the check box next to Lamp recover mode.
Image 5-16
Lamp recovery
5.6
Linked lamp output
5.6.1
About linked lamp output
Goal
When 2 projectors are projecting on the same screen, e.g. for projecting 3D images, then it necessary
that both projectors are using the same light output, otherwise a difference in brightness will be visible
between both images.
To obtain this goal, one projector will be set as master and this master will manipulate the target CLO
value of the slave so that the lamp output will be aligned between both projectors. When the lamp output
of the master changes, then the lamp output of the slave will follow.
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012
5. Installation
135