Touch Panel; Communication; Assign An Ethernet Address Via Dhcp To The Touch Panel - Barco DP2K Series User Manual

7. TOUCH PANEL

Overview
•

Communication

• User management
• User access settings
• Display properties
• Change Language
• Change units
• Touch panel Diagnostics
7.1 Communication
7.1.1

Assign an Ethernet address via DHCP to the Touch panel

How to set up
1. While in Touch panel, Communication tab page, tip Edit (1) button under Touch panel network proper-
ties. (image 7-1)
A message window opens if the check box never was checked in the past (2).
2. Tip OK (3).
The Change network settings window opens (4).
3. Check the check box next to Obtain an IP address automatically (DHCP) (5).
This selection will become active. Other selections are grayed out.
4. Tip on Apply to activate (6).
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012
7. Touch panel
215