Barco DP2K Series User Manual page 162

5. Installation
Mode
LUT-CLUT
PCF
MCGD
CSC-P7
INPUT
3D
SCREEN
MACRO
PNG
158
Explanation
Complex LUT lookup table.
Projector Configuration File. This file is a file that will be delivered with each
movie. It contains all data needed to display a certain movie as it is defined by
the movie distributor.
This file includes :
• LUT-CLUT data
• LUT-DG data
• Color Space Convertor data
• Target Color Gamut data
• Input data
Measured color Gamut Data
This file contains the measured color gamut data (color reference values) for a
specific projector installation. This type of file can be created with the 'measure
color gamut' function in the color gamut tab.
Color Space Convertor – P7
Normal projector use has the CSC-P7 values calculated based on MCGD and
TCGD parameters. Therefore, downloading CSC-P7 values is typically done for
debug purposes, rather than normal operation.
Input files contain information about the input:
Source selection
• Port 292-A Source Type and Packing
• Port 292-B Source Type and Packing
• Port 292-Dual Source Type and Packing
• Port DVI-A Source Type and Packing
• Port DVI-B Source Type and Packing
• Port DVI-Dual/Twin Source Type and Packing
Color spacing
Field bid and field dominance info
LUT-CLUT and LUT-DG information
3D settings
• Frame Rate Multiplication
• 3D Control commands (All)
Screen presentation configuration
These type of files include:
• Resizing information
• Letterboxing information
• Masking information
• Anamorphic factor of projector lens information
All information in the SCREEN file can be set with the Resizing, Masking and
Lens Type interface.
Macro files
Macro files contain a sequence of commands that need to be executed when
executing the macro file.
Portable Network Graphics files
These files are typically used as test patterns.
R59770488 COMMUNICATOR TOUCH PANEL 06/06/2012