Advertisement
HearthStone Quality Home Heating Products Inc
I
I
NSTALLATION
NSTRUCTIONS
S
FOR THE
TANDARD
T
M
ERMINATION
V
K
(K
ENTING
IT
IT
1. Install the 4" inner collar by first
placing the 4" x 6" gasket ring onto
the base of the collar. Install the
collar and gasket to the stove using 8
of the screws provided.
2. Install the outer collar in similar
fashion using the larger gasket ring
and the remaining 8 screws.
3. Install the 45º elbow over the outer
collar. Place the elbow so that the
twist lock end is pointing up.
4. Install one of the 24" pipe sections
into the elbow by fully inserting it
and turning approximately ¼ turn
clockwise, until the 2 sections are
fully locked. Install the 90º elbow in
similar fashion.
5. Move the stove and pipe assembly
back until the 90º elbow is flush to
the wall. The 24" vertical pipe
should be parallel to the wall. Draw a
circle around the pipe. Use the center
of this circle as the center point of
the 10" x 10" square wall pass
through. (It should be approximately
55" above the floor) Cut and frame
the wall pass through.
6. Place the interior wall thimble into
the 10" x 10" wall pass through.
Secure
it
with
provided). Install the exterior portion
of the thimble in similar fashion,
overlapping the 2 sections.
H
ORIZONTAL
INIMUM
#93-65000)
4
screws
(not
›
Caution: For building with vinyl siding,
a vinyl siding standoff should be installed
between the vent cap and the exterior
wall.
7. Install
termination on the outside of the
wall. Make sure both of the retaining
straps extend through interior wall
thimble. Before attaching the vent
termination to the outside of the
house, run a bead of non-hardening
mastic around its' outside edges, so
as to make a seal between it and the
wall. The arrow on the end cap
should point up. Secure the cap to
the wall with the appropriate screws.
8. Place the thimble cover onto the 90º
elbow. Put the 9" pipe into the
horizontal vent cap, (the vent pipe
must extend into the horizontal vent
cap a minimum of 1 -1/4"). Move the
stove and vent pipe into position,
insert the 9" pipe into the 90º elbow
and twist to lock it. Secure the straps
from the horizontal vent termination
to the interior pipe with 2 sheet metal
screws, keeping screws close to wall
thimble as possible. Bend or cut the
excess strapping so that the thimble
cover will fit properly. Screw the
thimble cover to the wall.
23
Champlain
Model #8300
the
horizontal
vent
Advertisement
