Table of Contents
Advertisement
Top Flue
1in. Min. (25mm)
A
A
B
Millimeter
837
413
Rear Flue
1 in. MIN. (25mm)
A
A
B
Millimeter
837
413
Figure 2.
Fireplace Dimensions, Locations, and
Space Requirements
B
E
D
C
½ in. Min (13mm)
C
D
E
728
1001
1416
B
E
D
C
1 in. MIN. (25mm)
C
D
E
843
1192
1686
Heat & Glo • SL-350TRSI-AUE • 2089-902 Rev. B • 6/06
Clearance Requirements
The top and back of fireplace are defined by stand-offs.
The heat shield must be attached as shown if combus-
tible materials are placed directly on top standoffs (Fig-
ure 3).
The minimum clearance to a perpendicular wall ex-
tending past the face of the fireplace is 25mm.
The back of the fireplaces may be recessed into com-
bustible construction, as shown above.
TOP
STANDOFFS
Figure 3.
Heat Shield
1.0 INSTALLATION INSTRUCTIONS
NOTE: Not intended for fireplace insert.
In planning the installation for the heater it is necessary
to determine where the unit is to be installed, the type
of flue system to be used (straight out, corner, or el-
evated), and whether optional accessories (wall switch
or remote control) are desired. Gas supply piping should
also be planned. Refer to the appliance data plate on
the base pan of the heater for all gas pressures and
input rate information.
The heater can be mounted on any of the following sur-
face:
1. A flat surface (minimum 6mm base).
2. Four (4) corner supports.
(Example: Four (4) concrete masonry blocks). These
supports must be positioned so they contact all four (4)
perimeter edges on the bottom of the unit.
Heater framing can be built before or after the heater is
set in place. Framing should be positioned to accom-
modate wall covering and heater facing material. The
heater framing should be constructed of 2" X 4" (51 x
102mm) lumber or heavier. The framing headers may
rest on the heater standoffs. Refer to Figure 2 and Fig-
ure 4 for heater and framing reference dimensions.
INSTALLED
HEAT SHIELD
HEAT SHIELD
5
Hide quick links:
Advertisement
Table of Contents
