Initial Brewer Set-Up - Bunn MCA Use And Care Manual

Remove Slide Lid (A) and Water Reservoir (N)
1
Thoroughly rinse the Water Reservoir then
2
fill to the MAX line.
NOTE: Filling the Water Reservoir is not
required for Automatic units with water line
installed.
Reinstall the Water Reservoir.
3
INITIAL BREWER SET-UP (MCP/MCPA)
CONTINUED
Plug in the brewer and turn on the
4
Power Switch (M).
NOTE: The "Refill Water Indicator" will
slowly flash until initial setup is complete.
Press the Pod Holder Release Button
5
(B) and pull the Pod Holder (F) out.
Rinse thoroughly and reinstall.
CAUTION: Always verify the Pod Holder is
locked into place before brewing.
CAUTION: Do not attempt to remove the Pod
Holder while brewing.
Place a cup that will hold a minimum of
6
14 oz. onto the Drip Tray Grate (G).
11