Automatic Section Initial Brewer Set-Up - Bunn MY CAFE MCA Use And Care Manual

For pour-over set-up, go to "Pour-Over Section" on page 12.
1. Remove the lid and
water reservoir.
(CAUTION: Do not place the brewer in a
sink or other water source.)
2. Thoroughly rinse the water reservoir.
3. Replace the reservoir
and lid and close the
slide lid.
4. To ensure the Pod
Holder is locked in
place, use thumb to
press the pod holder
release button to
eject the holder and
then press all the way
in to lock.
(CAUTION: You should hear a clicking sound
when the pod holder locks in place.)
5. Slide the volume
control lever to the
maximum setting.
6. Plug in the brewer
and turn on the
power switch.
"AUTOMATIC SECTION"
INITIAL BREWER SET-UP
P0214/2960
7. Place a mug or bowl that
will hold at least 14 fl. oz.
(414 ml) onto the drip
tray grate.
8. Press and release
the coffee brew
P3017
button to fill the
reservoir with
water.
9. Press and release
the coffee brew
button again to fill
the internal water
tank.
(CAUTION: Water may not immediately flow
P2903
from the brewer. Never remove pod holder
from brewer during a brew cycle.)
10. Empty any water in the mug or bowl and
place the mug back on the drip tray grate.
(NOTE: Wait for Heating Indicator to go out
before proceeding to Step #11.)
P2965
11. Press and release
the coffee brew
button a third time.
(CAUTION: Water should flow from the pod
holder. Wait until water drip out has finished
P2959
before removing the pod holder.)
You are now finished preparing the brewer
for it's first use. Proceed to the "Brewing
Delicious Coffee Or Tea" section.
10
P2961
P2958
P2958
P2958