Initial Brewer Set-Up - Bunn MCPA Use And Care Manual

1. Remove the lid and
water reservoir.
(CAUTION: Do not place the brewer in
a sink or other water source.)
2. Thoroughly rinse the water reservoir.
3. Fill the reservoir to the
maximum line with
fresh cold water.
4. Replace the reservoir and lid
and close the slide lid.
5. To ensure the Pod Holder
is locked in place, use
thumb to press the pod
holder release button to
eject the holder and then
press all the way in to
lock.
(CAUTION: You should hear a clicking sound
when the pod holder locks in place.)
6. Slide the volume
control lever to
the maximum
setting.
* Some noise is normal when the water pump is running.

INITIAL BREWER SET-UP

P3017
P2901
P2902
P2908
P2952
7. Plug in the brewer
and turn on the
power switch.
8. Place a mug or bowl that
will hold at least 414 ml (14
fl. oz.) onto the drip tray
grate.
9. Press and release
the coffee brew
button to fill the
internal water
tank.*
(CAUTION: Water may not immediately flow
from the brewer. Never remove pod holder
from brewer during a brew cycle.)
10. Empty any water in the mug or bowl and
place the mug back on the drip tray grate.
(NOTE: Wait for Heating Indicator to go out
before proceeding to Step #11)
11. Press and release
the coffee brew
button a second
time.*
(CAUTION: Water should flow from the pod
holder. Wait until water drip out has finished
before removing the pod holder.)
You are now finished preparing the brewer
for it's first use. Proceed to the "Brewing
Delicious Coffee Or Tea" section.
9
P0214/2905
P2904
P2907
P2907