Page 1
COMMERCIAL AND COMMERCIAL TYPE HOUSEHOLD TYPE The Bunn logo is a registered trademark of Bunn-O-Matic Corporation. My Café is a registered trademark of Bunn-O-Matic Corporation. RECORD MODEL & SERIAL NUMBER In order to receive accurate and timely warranty assistance, it is important to record the Model and Serial Number information located on the bottom of the brewer.
TABLE OF CONTENTS WARNINGS ...........................2 USER NOTICES ........................3 INTRODUCTION ........................3 SPECIFICATIONS ........................3 IMPORTANT HANDLING INFORMATION ................3 IMPORTANT SAFEGUARDS ....................4 SAVE THESE INSTRUCTIONS ....................4 GENERAL INFORMATION ......................5 FEATURES AND CONTROLS ....................6 DEFINITIONS ........................7 WATER INLET SET-UP ......................8 PLUMBING REQUIREMENTS ....................8 INITIAL BREWER SET-UP .....................9 BREWING DELICIOUS COFFEE OR TEA ................10 ROUTINE CLEANING ......................11 PERIODIC CLEANING/DESCALING ..................11...
Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www.bunn.com. # 37282.0000 # 00986.0002...
IMPORTANT SAFEGUARDS Follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • Do not insert or remove pod holder while • Read all instructions. brewing. Press the coffee or tea button to •...
• A power switch is provided on the lower left side to completely shut off all electrical components when your plans take you away from the brewer for three or more days. Safety features, designed into the BUNN Pod brewer, make the daily use of this switch ®...
FEATURES & CONTROLS SLIDE LID* POD HOLDER 46 oz. WATER RESERVOIR* RELEASE BUTTON SPRAYHEAD SEAL* SPRAYHEAD* POD HOLDER INSERT* HOLDER* DRIP TRAY GRATE* POWER SWITCH DRIP TRAY* WATER INLET BLUE (BREW) LIGHTS VOLUME CONTROL CONTROL PANEL SLIDE LEVER * Available replacement part at www.bunnomatic.com or call 1-800-870-0894 P2956 FIG 1.
The “On-Off-On” water flow is normal. Always wait for the blue (brew) lights to go out, and the red BUNN light to come back on before carefully removing the mug or pod holder. Pressing either brew button during this operation will stop the brew...
Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply line by this type of device may restrict water flow.
INITIAL BREWER SET-UP NOTE: Water light will slowly flash until -FILL RESERVOIR setup is complete. 1. On Pourover Models, Fill reservoir to Max. line. On Automatic -FILLING INTERNAL TANK Models, Plumb the 4. Place a mug or bowl unit to specifications. that will hold at least See page 8 14 fl.
CAUTION: hot water and hot pod will be volume selected, on the present. drip tray grate below the pod holder . NOTE: The red BUNN light will come back P2961 on indicating the brew cycle has finished. 4. Press and hold the pod holder release button 9.
URNEX Activated Descaler or JavaClean2 Cleaner and Descaler, available on our web ® site: www.bunn.com. (White vinegar can be used to descale if a descaling product is not available.) Follow the directions as printed on the manufacturer’s package. Fill the reservoir with descaling product as described by the manufacturer’s directions, or 32 oz.
PERIODIC CLEANING/DESCALING (Cont.) When the cycle has finished, empty the container. Repeat step 7 at least two more times to remove the solution from the tank. Clean the pod holder with a mild detergent and rinse thoroughly. 10) Proceed to the “Cleaning The Sprayhead/Seal” section. CLEANING THE SPRAYHEAD/SEAL Press the Power Switch into the off “O”...
CAUTION: The seal confines the hot liquid to the pod holder. Replace the seal if it becomes damaged. Parts are available at www.bunn.com. CLEANING THE POD HOLDER To prevent residue build up, it is a good idea to periodically disassemble the pod holder/screen assembly and clean it with a mild detergent.
TROUBLESHOOTING SITUATION EXPLANATION The REFILL WATER INDICATOR Pour-Over only: has come on. The WATER RESERVOIR has run low on water. Slide the lid open and pour additional water into the reservoir, or remove the reservoir and fill it at a sink, or other water source. CAUTION: Do not place the brewer in a sink or other water source.
Page 15
TROUBLESHOOTING (Cont.) SITUATION EXPLANATION (Continued) again. This is normal and will take about 45 The water shuts off and comes seconds to complete. Wait for the blue lights back on again when brewing. to go out. NOTE: Although the pulse brew process can be used for coffee or tea, it is designed to brew tea.
Page 16
POD HOLDER RELEASE BUTTON) is lit, this not on all of the time. indicates that the power to the machine is on. No action is required. The BUNN ® brewer is ready to brew. When the brewer enters a sleep mode the POD HOLDER BUTTON will not be glowing.
(at our exclusive option) either (1) arrange for the unit to be repaired, at no cost to you for parts or labor, by a Bunn Authorized Service Representative, (2) replace the unit at no charge to you or (3) refund the purchase price you paid for the unit.