Definitions - Bunn MCA Use And Care Manual

• SLEEP MODE - If the brewer has been idle for 6 hours, it will reduce power to
conserve energy. After 26 hours, the brewer will shut down completely. When
either of these two sleep modes occur, the Pod Holder Release Button will no
longer be glowing red. To wake the brewer up, press either the Coffee or Tea
Brew button, or eject the pod holder. The light and heater will come back on.
• BREW CANCEL - If it is necessary to cancel a brew cycle, this can be done by
pressing either the Coffee or Tea button again. Although some water may drip
out, the pump will immediately stop forcing water through the pod holder.
Always wait for hot liquid to stop before removing the pod holder.
CAUTION: When a brew cycle is canceled, it will not finish dispensing it's previous
brew volume when the button is pressed again. The memory is reset and the
brewer will dispense a full volume as indicated by the Volume Control Lever. This
could cause a container to overflow if it is not emptied prior to pressing the button
a second time.
• MIN & MAX MARKINGS - The side of the water reservoir bears the markings
"MIN" and "MAX". These markings indicate the minimum and maximum
amount of water that can be placed in the reservoir. If the minimum amount of
water is not in the reservoir, the brewer will not operate. These markings are
referenced throughout this booklet.
• PULSE BREW™ - Using the Tea Button will cause the brewer to perform a
pulse brew operation. A Pulse Brew cycles the water on and off to effectively
steep the tea to extract the proper flavor. The "On-Off-On" water flow is normal.
Always wait for the blue (brew) lights to go out, and the red BUNN light to come
back on before carefully removing the mug or pod holder. Pressing either brew
button during this operation will stop the brew cycle. (See the "Brew Cancel"
feature above for more information.)

DEFINITIONS

9