Advertisement
REAR PANEL DESCRIPTION
MP 2S
COMMERCIAL AUDIO
This device complies with Part
EQUIPMENT 24TJ
100-240 V
15 of the FCC Rules. Operation
50/60 Hz 7 WATTS
is subject to the following two
conditions:
R
(1) this device may not cause
harmful interference, and
(2) this device must accept any
interference received, including
ACN 001 345 482
interference that may cause
undesired operation.
RANE CORP. MADE IN U.S.A.
8
1 PHONO/LINE 1 & 2 INPUTS: are switchable from a PHONO (RIAA) stage for magnetic cartridges (PHONO, switch in) to a
LINE level Input suitable for any line level device such as a CD player (LINE, switch out). The PHONO GROUND screw con-
nects to those extra green wires coming out of the turntables.
2 LINE 1 & 2 INPUTS: connect to stereo sources such as CD players or any line-level device. L1 and L2 may be assigned to Pro-
gram A or Program B via the front panel INPUT switches.
3 MIC Input: accepts a ¼" balanced (TRS) or unbalanced (TS) microphone cable, controlled by the MIC LEVEL control on the
front panel.
4 HOUSE OUTPUT: The front panel HOUSE LEVEL control affects the volume at this Output. These balanced ¼" TRS (tip-
ring-sleeve) Outputs connect to a balanced equalizer or amplifier. Though not recommended, unbalanced ¼" TS (tip-sleeve)
cables may be used for short runs (under 3 meters [10 feet]) to an amplifier with unbalanced inputs. See the RaneNote "Sound
System Interconnection" for wiring recommendations.
5 AUX OUTPUT: This delivers the same signal as the HOUSE OUTPUT, but has its own LEVEL control on the rear panel. This
Output is not affected by the front panel HOUSE LEVEL control. These balanced ¼" TRS (tip-ring-sleeve) Outputs connect to a
balanced equalizer or amplifier (for a possible second listening zone) and follow the same interconnection rules as above.
6 TAPE OUTPUT: These line-level RCA Outputs are intended for use with a tape recorder, but not necessarily restricted to that
purpose. Be creative! These Outputs are not affected by the HOUSE LEVEL or AUX LEVEL controls.
7 MIC to TAPE switch: In the YES position the Mic signal along with the Program Inputs are routed to the TAPE OUTPUT.
In the NO position only the Program Inputs appear at the TAPE OUTPUT.
8 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. With the right cord, you can plug anywhere in the
world between 100 and 240 VAC. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connec-
tion!
4
5
HOUSE
AUX
BALANCED OUTPUTS: TIP =
, RING =
, SLEEVE = SIGNAL GROUND
RIGHT
LEFT
RIGHT
LEFT
7
MIC TO TAPE
L
NO
YES
R
LEVEL
TAPE OUTPUT
L2
6
2
L
L
PHONO GROUND
R
R
LINE
LINE
P2
L1
P1
PHONO
PHONO
1
BALANCED MIC INPUT
MIC
3
Manual-
Advertisement
