Operating The Mower; Height Of Cut - Hayter Ranger 53 Pro Owner's Handbook Manual

Hayter mowers lawn mower owner's handbook

Hide thumbs Also See for Ranger 53 Pro:

Owner's handbook manual (40 pages)

Owner's handbook manual (44 pages)

Table Of Contents

Table of Contents

1.17

SAFETY NOTICE

Continued

WARNING: PREVENT ACCIDENTS Before mowing,

thoroughly inspect the area where the mower is to be

used and remove all stones, sticks, wires, bones and

other foreign objects, which when contacted by the

mower cutterbar could become dangerous projectiles.

Inspect the area for hidden obstructions which when

contacted by the cutterbar could risk health and safety.

Remember the location of these obstructions and ensure

that you mow around them.

CAUTION: Prevent engine damage - DO NOT use the

mower on a slope greater than 20 degrees.

HEIGHT OF CUT

To adjust the height of cut : Grip the lever and pull side-

ways to disengage it from the locking notch, then push for-

wards to raise or pull backwards to lower the height of cut.

Finally release the lever at the required position and ensure

it locks firmly into one of the eight setting notches.

Always select a height of cut to suit operating conditions.

Aim to prevent engine overloading and blockages by avoid-

ing low cuts in long grass conditions. Be prepared to make

two cuts when the grass is long.