In-dash double-din dvd/mp3/cd/am/fm receiver with 6.2 (157mm) widescreen touchscreen tft digital monitor usb and sd memory card ports and front panel aux input (29 pages)
Bluetooth -enabled double-din dvd/mp3/cd receiver with 6.2'' widescreen touchscreen tft digital monitor usb and sd memory card port and front panel aux input (10 pages)
Page 1
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com...
Page 2
Preface Thank you for purchasing this car audio product. Please read this manual carefully before operating this car audio product. Please keep this manual for future use. It will be helpful to you if you are encounter any operational problem. Selecting fine audio equipment is only the start of your musical enjoyment.
LOCATION AND FUNCTION OF CONTROLS SPECIFICATION GENERAL Supply Voltage DC 12 V. Negative Ground Current Consumption Max.10A P38 5UA Power Output 4 X 60W Number of channels 2 STEREO channels. MODE Unit Dimensions (L X W X H): 7" X 6.46" X 1.97" BAND 178 X 164 X 50 mm LOUD...
b) When pressed and hold for 2 seconds, it is activated as cyclical mode of TROUBLE SHOOTING ’ following functions for user s selection. ->BEEP (ON/OFF) -> USER SET(FLAT/CLASSIC/ROCK/POP) Before using the check list please make all the connections first. ->SUBW(ON/OFF)->VOL(LAST/DEFA) ->CLK(ON/OFF)->CLK(12/24)mode.
7. BAND BUTTON CARE FOR USING CD'S: During radio mode, press the BND button briefly to select the radio broadcasting band you would like to hear. The AM/FM band is toggled cyclically through the About CD-R/CD-R/W discs: tuning bands: ->FM 1-> FM 2 -> FM 3 -> AM 1->AM2 ->. In addition to commercially-recorded audio CD's, this unit can play CD-R and CD-R/W discs.
12. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS INSTALLATION a) During radio mode: Go to any preset station by pressing one of the 6 preset station buttons (1-6). If one of these buttons is pressed for more than 2 seconds, the station currently INSTALLATION METHOD being listened to will be memorized into the selected preset button.
WIRES CONNECTION 17. SCAN BUTTON Press the SCN button to scan the radio frequency. If a valid signal has detected, FRONT RIGHT RCA OUTPUT REAR RIGHT RCA OUTPUT the current frequency will be hold and blinking for 5 seconds, then press SCN again to stop scan and remain the current frequency;...
MAINTENANCE OF REMOTE CONTROL OPERATION OF REMOTE CONTROL An insulation tag was installed in your remote by the manufacturer to prevent the 1. Power On/Off battery from draining. Removing the tag from the remote before using. POWER 2. Mute Button Loudness Button MUTE SELECT...