One din in-dash am/fm dvd/mp3/cd receiver with 7" (178mm) widescreen touchscreen tft digital monitors with dual (front and rear)usb and sd memory port and aux input
Bluetooth-enabled in-dash single din am/fm dvd/mp3/cd receiver with 7-inch widescreen touchscreen digital tft monitor with dual (front and rear) usb abd sd memory port and aux input (10 pages)
In-dash single din am/fm dvd/mp3/cd receiver with 7-inch widescreen touchscreen digital tft monitor with dual (front and rear) usb and sd memory port and aux input (11 pages)
Bluetooth-enabled in-dash double-din dvd/mp3/cd/am/fm receiver with 7" (178mm) motorized widescreen touchscreen tft digital monitor usb and sd memory card ports and front panel aux input (18 pages)
Bluetooth-enabled one din in-dash am/fm dvd/mp3/cd receiver with 7" widescreen touchscreen tft digital monitor with dual usb and sd memory card port and aux input (12 pages)
In-dash double-din am/fm dvd/mp3/cd receiver with 6.2" (157mm) widescreen touchscreen tft digital monitor with dual (front and rear) usb and sd memory port and aux input (10 pages)
Bluetooth-enabled, in-dash am/fm dvd/mp3/cd reciever with 3.2 inch widescreen tft monitor with usb and sd memory ports and front panel aux input (24 pages)
Bluetooth -enabled double-din dvd/mp3/cd receiver with 6.2'' widescreen touchscreen tft digital monitor usb and sd memory card port and front panel aux input (10 pages)
BASIC FUNCTION INSTRUCTIONS 12. Number Button 6 / /OPEN Button In playback mode, press the button to adjust the angle of screen. Press the button to open / close the screen. Press this button for short moment to turn on power, and long press it to turn off power. 13.
Remote Control Operation INSTRUCTIONS 14. 0-10+ Button 23. ANGLE Button 、 Press this button to choose desired song In DVD mode, press this button to change 3. SOURCE Button section、preset stations. play angle. Press this button to change mode. Decimal numbers, for example the 19th song, press 10+ and 9 button.
Turn on/off Radio Operation 1. Enter/exit When the ignition switch is put in ACC or ON position, Press power button on the front Touch [Radio] icon in the main interface to enter into the radio interface. panel to turn on the unit. After the host starts, hold power button for 3 seconds, the host Touch icon to return to main interface, and then touch other function icons so as to will turn off.
Disc Operation INSTRUCTIONS 1. Play/eject disc Return to root menu Play disc Touch this icon, it shall return to root menu of disk in DVD state and access PBC menu Insert the disc into the disc slot with the printing surface up, system will detect the disc playing in VCD state.
ST. Wheel setting Other Operation 1. Click on the [ ] icon in the main interface into the SWC. settings interface. Rear view function In any running state, the video signal can switch to reverse video state when reversing 2. The original vehicle to the control line positive, the car, and the system shall return to its initial running state after reversing the car.
Access setup interface INSTRUCTIONS Click [Setting] icon on main interface to access setup interface. Version Touch the icon [ ]in setting interface to enter the General setting interface below to check the software version number of DISC/MCU/TFT ( Click icon on setup interface to access general setting The version information is displayed interface, as shown in below PIC 1 diagram: please prevail in kind.)
Touch screen Calibration WIRING DIAGRAM This player is equipped with ISO standard connector, please follow below instruction: Please follow the below instructions to calibrate when there is no touch or Red - ACC ON (+12V) Grey/Grey black - Right front speaker (+/-) touch is not accurate.
INSTRUCTIONS INSTRUCTIONS SPECIFICATIONS ACCESSORY Power supply DC 12V Accessory Quantity Power range 10.8-16.0V DC Max Current Consumption Wire Ground system Negative ground Power Output 85 WattsX4 Channels USB Cable FM tuner Remote Controller US frequency range 87.5-107.9MHz European frequency range 87.5-108MHz Warranty card 2PCS...