Rj-11 Connector Cable - HP EliteBook 8560w Maintenance And Service Manual

6. Remove the three Torx 9M2.5×4.0 screws (2) that secure the system board to the base
enclosure.
7. Remove the two Torx 9M2.0×8.0 screws (3) that secure the system board to the optical drive
connector.
8. Remove the system board (4) from the base enclosure.
Reverse the preceding procedure to install the system board.

RJ-11 connector cable

NOTE: The RJ-11 connector cable is included in the Cable Kit, spare part number 652662-001.
Before removing the RJ-11 connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Battery on page 45).
Service access cover on page
Hard drive on page 57)
Optical drive on page
Keyboard on page 64)
Top cover on page 68)
62)
Component replacement procedures 105
47).