Security Lock - HP EliteBook 8560w Maintenance And Service Manual

Security lock

NOTE: The security lock is included with the base enclosure assembly, spare part number
652649-001.
Before removing the security lock, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
e. Video card fan/heat sink assembly (see
f. Processor heat sink (see
g. System board (see
Remove the security lock:
1. Position the computer right-side up with the front toward you.
2. Remove the Torx 9M2.5×6.0 screw (1) that secures the security lock to the base enclosure.
3. Remove the security lock (2) at an angle from the base enclosure.
Battery on page 45).
Service access cover on page
Hard drive on page 57)
Optical drive on page
Keyboard on page 64)
Top cover on page 68)
Processor heat sink on page
System board on page
62)
Video card fan/heat sink assembly on page
83)
103)
Component replacement procedures 111
47).
81)