Troubleshooting - Grundig RRCD 2700 MP3 Manual

INFORMATION

Troubleshooting

If a fault occurs, first refer to this information before you take the device for repair.
If you are unable to rectify the fault using the information given here, contact your local deal-
er or service specialist.
Under no circumstances should you attempt to repair the radio recorder yourself, as this
would invalidate the guarantee.
PROBLEM
GENERAL
INFORMATION
No sound
The radio recorder does
not react when the buttons
are pressed
RADIO
Poor radio reception
CD
Playback will not start
The CD player skips tracks
CD-Rs or CD-RWs are not
being played back, or
being played back
incorrectly
TAPE
Poor tape playback sound
quality
No tape recording
_______________________________________________
POSSIBLE CAUSE
Volume is too low,
headphones are connected,
batteries are flat,
batteries are incorrectly inserted
Power cord incorrectly connected
Static electrical discharge
Weak radio antenna signal
Interference from electrical devices
such as televisions, video recorders,
computers, neon lamps etc.
The CD is damaged or dirty
A stored playlist is being played
The RANDOM function is activated
The CD is faulty or the software or
hardware settings were incorrect
during burning
Dust and dirt on magnetic heads,
capstans or idlers
Recording protection tab has been
broken off
REMEDY
Increase volume,
disconnect the headphones
Insert new batteries.
Insert batteries correctly
Connect power cord correctly
Switch off the device, disconnect the
mains cable and plug it in again
after a few seconds
Remove any batteries
VHF (FM): tilt and turn thetelescopic
antenna
MW: turn the whole device
Keep the radio recorder away from
electrical devices
Replace or clean the CD
Switch to normal playback or delete
Switch off the RANDOM function
Check the components of your CD
burner/burner software or change
the CD you are using
Clean the magnetic heads, capstan
and idler
Cover the opening with adhesive
tape
35