General Functions; Switching On And Off; Selecting The Input Source; Adjusting The Volume - Grundig RRCD 2700 MP3 Manual

GENERAL FUNCTIONS

Switching on and off

1 Switch on the device with the input source by moving the
switch to the corresponding position.
2 Move the »RADIO OFF/TAPE
the device.

Selecting the input source

Select the input source (CD, TAPE or RADIO) using
1

Adjusting the volume

Press » + VOL. –« to adjust the volume.
1
Switching the Ultra Bass System on and off
This function boosts the bass frequencies.
Switch the Ultra Bass System on and off by pressing »UBS«.
1

Listening with headphones

Connect the headphones to the »0« headphone jack (ø 3.5 mm).
1
– This switches off the loudspeakers.
Note:
Excessive sound pressure from the earphones or headphones can cause hearing loss.
RADIO MODE
Antennas
For FM stations (VHF) extend the telescopic antenna »Antenne«.
1
Note:
If the FM signal is too strong, it is advisable to push in the telescopic antenna.
The radio has a built-in rod antenna for MW reception. Turn the device around to align
2
the antenna.
Selecting the radio input source
1 Move the »RADIO OFF/TAPE
Selecting radio stations
1 Press »FM MONO FM STEREO
Select the radio station with »TUNE«.
2
– The frequency is displayed on the frequency scale.
__________________________________
CD« switch to the »OFF/TAPE« position to switch off
»RADIO OFF/TAPE
_________________________________________________
CD« switch to the »RADIO« position.
MW« to select the frequency band (FM or MW).
»RADIO OFF/TAPE
CD«.
CD«
27