Back To Factory Defaults; Restart Screen; Led Screen - ZyXEL Communications WRE 2205 User Manual

Chapter 9 Tools
Figure 43 Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default WRE2205 IP address (192.168.1.2). Refer
to your operating system's help files for details on how to set up your computer's IP address.

9.4.3 Back to Factory Defaults

Pressing the Reset button on the Maintenance > Tools > Configuration screen clears all user-
entered configuration information and returns the WRE2205 to its factory defaults.
You can also press the WPS button on the front panel for more than 10 seconds to reset the factory
defaults of your WRE2205. Refer to
the WRE2205.

9.5 Restart Screen

System restart allows you to reboot the WRE2205 without turning the power off.
Click Maintenance > Tools > Restart. Click Restart to have the WRE2205 reboot. This does not
affect the WRE2205's configuration.
Figure 44 Maintenance > Tools > Restart

9.6 LED Screen

Click Maintenance > Tools > LED. Use this screen to configure which LEDs are enabled or disabled.
Figure 45 Maintenance > Tools > LED
58
Section 2.3 on page 14 for more information on the resetting
WRE2205 User's Guide