Table of Contents
Advertisement
www.raisecom.com
E1-LOOP
31
Dip-switch
3. Interface on front panel
There are E1 and PC-AGENT ports on front panel.
Table 3-20 RCMS 2811-120FE Front Panel Description 6-Interface
NO.
32
1-4
LNK-UP
33
LNK-DWN
E1 Loop-back Test
The E1 loop-back position can be configured by SEL Bit4 dip-switch. Remote loop-back and local
loop-back are shown in following figure 3-11 and 3-12.
Bit Error
Tester
E1
Bit Error
Tester
E1
NOTE: 1. Please make sure that there is no alarm on optical port before configuring the remote E1 loop-back.
2. When configuring any loop-back on local multiplexer, all E1 loop-back dip-switches on remote
multiplexer must be OFF in default.
4 bits
Bit1-4 the 1
Bit1 = OFF , the 1
Bit1 = ON, the 1
The configuration method of Bit2 to Bit 4 is same as Bit 1.
Name
Bits
RJ45 and
1
BNC
interface).
RJ45
Local network management interface. LNK-UP connects to PC serial
port or connects to upper device's LNK-DWN interface when
concatenating. It complies with RS232 electrical standard and the baud
rate is 19200bps.
RJ45
LNK-DWN
concatenating. It complies with
baud rate is 19200bps.
Multi-
core
Local
Figure 3-11 sketch map of setting remote loop-back on local site
Multi-
core
Local
Figure 3-12 sketch map of setting local loop-back on local site
st
th
to 4
E1 tributary loop-back configuration.
st
E1 tributary is not loop-back;
st
E1 tributary is loop-back.
st
th
-4
E1 tributary interface (750Ω is BNC interface and 120Ω is RJ45
connects to upper device's
Fiber
Fiber
Description
LNK-UP interface when
RS232 electrical standard and the
Multi-
core
Remote
Multi-
core
Remote
User Manual
E1
E1
15
Advertisement
Table of Contents
