Advertisement
INSTALL INSTRUCTIONS C-TCB-12
TOOLS REQUIRED:
3/16" Allen wrench
3/8" Standard socket set
3/8" Torx set
HARDWARE & COMPONENTS:
QTY DESCRIPTION
1
Pole support assembly
1
Telescoping pole assembly
1
Side support brace
1
5/16-18 Nylock nut
1
5/16" Flat washer
2
¼ x 1Hex head lag bolt
Telescoping pole
assembly
Pole support
assembly
TELESCOPING COMPUTER BASE
1992-1996 FORD BRONCO
3/8" Ratcheting wrench
Open-end wrench set
Powered drill w/ 3/8" drill bit
PART #
CM93071-12
CM93072-3
CM93162
GSM30017
GSM31006
GSM33060
Side support brace
¼" x ¾"Hex
head lag bolts
5/16-18 Nylock
nut
C-TCB-12-INST-7-05
Advertisement
Table of Contents
Related Manuals for Havis-Shields Telescoping Computer Base C-TCB-12
Summary of Contents for Havis-Shields Telescoping Computer Base C-TCB-12
- Page 1 INSTALL INSTRUCTIONS C-TCB-12 TELESCOPING COMPUTER BASE 1992-1996 FORD BRONCO TOOLS REQUIRED: 3/16” Allen wrench 3/8” Standard socket set 3/8” Torx set HARDWARE & COMPONENTS: QTY DESCRIPTION Pole support assembly Telescoping pole assembly Side support brace 5/16-18 Nylock nut 5/16” Flat washer ¼...
- Page 2 1. Confirm receipt of all hardware and components. 2. Loosen or remove front inner and outer passenger seat bolts on vehicle. Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Need help?
Do you have a question about the Telescoping Computer Base C-TCB-12 and is the answer not in the manual?
Questions and answers