Havis-Shields Dual In-Dash Microphone Clip Bracket 1996-2007 Ford Crown Victoria C-MCB-CV Install Instructions

Dual in-dash microphone clip bracket for 1996-2007 ford crown victoria

INSTALL INSTRUCTIONS C-MCB-CV

DUAL IN-DASH MICROPHONE CLIP BRACKET

TOOLS REQUIRED:

Ratcheting wrench

Sockets - 7/16", #10, #8

Read all instructions before installing any Havis-Shields Equipment Corp products.

Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles

computer a false reading, causing a warning light on the instrument cluster. This requires the

vehicles' computer to be reset with a vehicle diagnostics tool.

Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

Use only hardware provided with install kit.

For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html, email

800-524-9900 and ask for technical support.

Police Package Crown Vic Dash.

1996-2007 FORD CROWN VICTORIA

Carefully remove trim panel

Screwdriver set

T-20 torx bit

Always

technicalsupport@havis.com

or call 1-

Remove hex head trim screws

shown above

C-MCB-CV-INST-6-07

Table of Contents

Do you have a question about the Dual In-Dash Microphone Clip Bracket 1996-2007 Ford Crown Victoria C-MCB-CV and is the answer not in the manual?

Page 1 Ratcheting wrench Sockets - 7/16”, #10, #8 Read all instructions before installing any Havis-Shields Equipment Corp products. Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles computer a false reading, causing a warning light on the instrument cluster. This requires the vehicles’...
Page 2 Replace screws previously Slide bracket between trim around Re-attach trim panel removed radio and the trim panel previously removed Final assembly Install microphone clip brackets using #8 x ½” machine screws and hex nuts C-MCB-CV-INST-6-07...

C-mcb-cv