Advertisement
Quick Links
3
INSTALL INSTRUCTIONS C-TCB-28
TOOLS REQUIRED:
Ratcheting wrench
3/8" Metric Socket Set
T-20 torx bit
3/8" Standard Socket Set
HARDWARE:
QTY DESCRIPTION
4
¼" x 1" Hex head lag bolt
1
5/16" Flat Washer
1
5/16" Nylock Nut
1
"Z" Bracket Support
1
¼" x ¾" Carriage Bolt
1
¼" Serrated Nut
1
Pole Support Assembly
1
Lateral Support Brace
1
Inner Telescoping Pole Assembly
Disconnect the vehicles' battery. Removing seat bolts on some vehicles may give the
vehicles computer a false reading leading to warning lights on dash. This requires the
vehicles' computer to be reset.
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email
1-800-524-9900.
1997-2007 DODGE DAKOTA
TELESCOPING COMPUTER BASE
Combination wrench set
Powered Drill
Drill Bit set
PART #
GSM33060
GSM31006
GSM30017
CM002001
GSM32000
GSM30023
CM93071-28W
CM93146
CM93072-3
Always
!
technicalsupport@havis.com
or call
Advertisement
Related Manuals for Havis-Shields 1997-2007 Dodge Dakota Telescoping Computer Base C-TCB-28
Summary of Contents for Havis-Shields 1997-2007 Dodge Dakota Telescoping Computer Base C-TCB-28
- Page 1 This requires the vehicles’ computer to be reset. Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit.
- Page 2 CM93072-3 CM93146 CM93071-28W Location of factory seat bolts Remove front bolts on passenger- Install “Z” support bracket to base side seat and position base assembly assembly using ¼ x ¾” carriage bolt in front of seat mount brackets. and serrated nut. Re-attach front bolts on passenger- side seat through C-TCB base plate.
- Page 3 Loosely attach lateral support brace Pre-drill floor of vehicle with 3/16” Attach support brace to floor using to TCB base using 5/16” flat washer drill bit. Use holes in the support ¼” x 1” hex head lag bolts brace as a drill template and 5/16”...