Advertisement
Table of Contents
INSTALL INSTRUCTIONS C-TM-IMP-1
TOOLS REQUIRED:
Ratcheting wrench
Standard Socket set
HARDWARE:
QTY DESCRIPTION
1
18" Length Extrusion
1
12" Length Extrusion
1
Transmission Hump Bracket (no holes drilled)
1
Rear Extrusion Bracket
1
Extrusion Adapter Bracket
12
¼" Serrated Nut
12
¼ x ¾" Hex Head Bolt
6
¼" x ¾" Phillips pan head machine screws
6
¼" Flat washers
2
#10 x ¾" Phillips pan head machine screws
6
¼" x ¾" Hex Head Lag Bolts
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email
1-800-524-9900.
C-TM-IMP-1
Transmission
Hump Bracket
(C-B43)
Guide bracket
Under seat
adapter bracket
HEAVY DUTY TRAK MOUNT
2006-2009 CHEVROLET IMPALA
Always
Extrusion
Adapter Bracket
Open-end wrench set
Screwdriver Set
PART #
CM93055-2
CM93055-1
C-B43
CM001380
CM001379
GSM30023
GSM33001
GSM33124
GSM31000
GSM33119
GSM33060-1
!
technicalsupport@havis.com
18" Length
Extrusion
Rear Extrusion
Bracket
C-B42
or call
12" Length
Extrusion
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1
Summary of Contents for Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1
- Page 1 #10 x ¾” Phillips pan head machine screws ¼” x ¾” Hex Head Lag Bolts Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email...
- Page 2 SUB ASSEMBLY: 1. Confirm receipt of all hardware and components. 2. Remove partial OEM cup-holder/console located on the transmission hump. Note: Do not remove metal housing attached to this partial console. This piece is meant to strengthen the vehicles crumple zone and must not be removed. INSTALLATION: View of partial OEM console removed...
- Page 3 Cut floor mat, next to the seat rail to allow Under seat support bracket to slide under seat rail Attach rear extrusion bracket to 12” portion of extrusion using (2) ¼-20 x ¾” bolts and serrated nut Slide under seat support brackets into position as shown 1.
- Page 4 C-TM-IMP-1 installed C-TM-IMP-1 installed w/ console, computer mounts and accessories. (Sold separately) C-TM-IMP-1_INST_11-08...
Need help?
Do you have a question about the Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1 and is the answer not in the manual?
Questions and answers