Havis-Shields 2000-2005 Chevrolet Impala Trak-Mount Kit C-TM-IMP Install Instructions

For 2000-2005 chevrolet impala trak-mount kit

Advertisement

INSTALL INSTRUCTIONS C-TM-IMP
2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT

TOOLS REQUIRED:

Ratcheting Wrench
Metric Socket Set
Torx Bit Set

HARDWARE:

QTY DESCRIPTION
8
¼" x ¾" hex head bolt
8
¼" Serrated nut
6
¼" x 1" Hex head lag bolts
1
32" Trak mount

SUB ASSEMBLY:

1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Brackets in relation
to Trak.
• Bolt Trak to Hump Brackets, using measurements taken in previous step
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets
to side of Trak Plate that has ¼" hardware slots closer together, to better accept equipment,
(consoles, control heads, etc)
• Slide (6) ¼-20 x ¾" Hex Head Bolts into ¼" Hardware Slots.
• With bolts in Trak, position Hump brackets.
• There is a left and right side to the Rear Hump Brackets. Top of brackets will be
parallel to the transmission hump.
• Attach ¼" serrated nuts and tighten.
TRAK-MOUNT ASSEMBLY
(Image Upside down)
Rear Hump Bracket C-B27
¼" Hardware Slots
Standard Socket Set
Tape Measure
PART#
GSM33001
GSM30023
GSM33060
CM93055-9
Front Hump Bracket C-B17
Trak

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2000-2005 Chevrolet Impala Trak-Mount Kit C-TM-IMP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Havis-Shields 2000-2005 Chevrolet Impala Trak-Mount Kit C-TM-IMP

  • Page 1 INSTALL INSTRUCTIONS C-TM-IMP 2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT TOOLS REQUIRED: Ratcheting Wrench Metric Socket Set Torx Bit Set HARDWARE: QTY DESCRIPTION ¼” x ¾” hex head bolt ¼” Serrated nut ¼” x 1” Hex head lag bolts 32” Trak mount SUB ASSEMBLY: 1.
  • Page 2 INSTALLATION: 1. REMOVE SEATS: • Remove rear seat base torx bolts. • Slide seat to rear most position. • Seats do not have to come out of vehicle, they will just need to be tilted out of way to place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats. 2.

This manual is also suitable for:

C-tm-imp

Table of Contents