Advertisement
Quick Links
INSTALL INSTRUCTIONS C-TM-CV
1995-2007 FORD CROWN VICTORIA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting Wrench
Metric Socket Set
HARDWARE:
QTY DESCRIPTION
10
¼" x ¾" Hex head bolt
6
¼" Serrated nut
4
¼" Flat washer
4
¼" Split lock washer
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Bracket in relation to
Trak.
• Bolt trak to the front hump bracket, top plate using measurements taken in previous
step. Use (4) ¼-20 x ¾" Hex head bolts and serrated nuts.
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets to
side of Trak Plate that has ¼" hardware slots closer together, to better accept equipment, (consoles,
control heads, etc)
TRAK-MOUNT ASSEMBLY
Front Hump
Bracket (C-B33)
Standard Socket Set
Tape Measure
Trak Mount
Rear Hump
Brackets (C-B16)
PART#
GSM33001
GSM30023
GSM31005
GSM31026
¼" Hardware
Slots
Advertisement
Related Manuals for Havis-Shields 1995-2007 Ford Crown Victoria Trak-Mount Kit C-TM-CV
Summary of Contents for Havis-Shields 1995-2007 Ford Crown Victoria Trak-Mount Kit C-TM-CV
- Page 1 INSTALL INSTRUCTIONS C-TM-CV 1995-2007 FORD CROWN VICTORIA TRAK-MOUNT KIT TOOLS REQUIRED: Ratcheting Wrench Metric Socket Set HARDWARE: QTY DESCRIPTION ¼” x ¾” Hex head bolt ¼” Serrated nut ¼” Flat washer ¼” Split lock washer SUB ASSEMBLY: 1. MOUNT TRAK TO HUMP BRACKETS. •...
- Page 2 • Attach trak to rear hump bracket using (2) ¼-20 x ¾” Hex head bolts and serrated nuts. Note: There is a driver and passenger side bracket to the Rear Hump Bracket. Top of brackets will be parallel to the transmission hump. INSTALLATION: 1.