Advertisement
Quick Links
INSTALL INSTRUCTIONS for KK-F-VAK
FORD VAN REAR AIR VENT ADAPTER KIT
TOOLS REQUIRED:
Ratcheting wrench
Standard & Metric Socket Set
HARDWARE:
QTY DESCRIPTION
1
Heat/Cool Adaptor box assembly
1
Ford Rear Air Hose Adapter
1
Ford Heat/Cool Box mounting channel
10
Hose Clamps 3"
2
4" Hose Clamps
4'
4" Diameter Hose
4
Vent cover w/ hose adapter assembly
1
2 ½" "Y" Duct Connector
1
2 ½" Air Duct Hose
1
2 ½" Air Duct Hose
1
2 ½" Air Duct Hose
2
2 ½" Air Duct Hose
20
#10 X ¾" Sheet Metal Screws
20
#10 Star Washers
20
#10 x ¾" Flat Head Sheet Metal Screws
20
15" Wire Tie
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email
1-800-524-9900.
8 foot length
7 foot length
6 foot length
4 foot length
Always
Screwdriver set
Wire cutters
PART #
KKM01152
KKM01153
KKM99071
GSM20045
GSM20042
GSM40100
KKM0403-001
PRM97483
PRM97475
PRM97475
PRM97475
PRM97475
GSM33195
GSM31034
GSM34151
GSM20036
!
technicalsupport@havis.com
or call
Advertisement
Related Manuals for Havis-Shields Ford Van Rear Air Vent Adapter Kit KK-F-VAK
Summary of Contents for Havis-Shields Ford Van Rear Air Vent Adapter Kit KK-F-VAK
- Page 1 #10 x ¾” Flat Head Sheet Metal Screws 15” Wire Tie Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email...
- Page 2 Remove the hex head screw on Remove the vent cover Remove the hex head lag bolt the vent cover mpletely. It will not be re-use ocated above the blower motor of the OEM rear HVAC unit Remove the hex head lag bolt Remove the hex head screws on Remove the intake cover.
- Page 3 Align the assembly so the hole in the assembly lines up with the “J clip”. Re-attach using the hex head lag bolt removed earlier Tighten the clamp that holds the hose to the assembly Now the HVAC adapter kit is fastened to the OEM unit.
- Page 4 Route HVAC 2 1/2” blower hoses to the approximate locations with tape along ceiling where they will be installed into the ceiling insert after Kwik-Kit insert is installed. Mount hoses with wire ties at wall and ceiling corners only. Leave enough slack to reach hoses for permanent mounting.
Need help?
Do you have a question about the Ford Van Rear Air Vent Adapter Kit KK-F-VAK and is the answer not in the manual?
Questions and answers