Table of Contents
Advertisement
Quick Links
INSTALL INSTRUCTIONS KK-ST-FLIP
(For Rear Permanent Mount Step order with KK-x-ST-RP)
TOOLS REQUIRED:
Ratcheting wrench
Standard socket set
Open-end wrench set
HARDWARE:
QTY DESCRIPTION
10
½" x 1 ½" Hex head bolt
4
½" x 3 ½" Hex head bolt
32
½" Flat washer
10
½" Lock washer
4
½" Nylock nut
10
½" Hex nut
2
¼" Stainless nylock nut
SUB ASSEMBLY:
1. Confirm receipt of all parts.
2. Flip down portion of step will come assembled.
3. Slide Support Channels into the Step.
4. Bolt together using (4) ½" x 4" Hex Head Bolts, ½" Nylock Nuts, ½" Flat Washers.
Note: Be sure that flat side of Support Channels face towards outside of vehicle
1. MOUNT FRAME BRACKETS:
• Determine Driver and Passenger side Frame Brackets using view on final page.
• Line brackets up with holes in frame rail of vehicle.
• Bolt brackets to frame using (4) ½" x 1 ½" Hex Head Bolts, ½" Hex Head Nuts,
½" Flat Washers, and ½" Lock Washers
• Do not tighten hardware at this time.
Note: FORD VANS Only: You must use a spacer between the Frame Rail and the Frame
Bracket on the forward mounting holes. Use (2) ½" Supplied flat washers
2. MOUNT STEP AND RAIL ASSEMBLY:
• Step can be mounted at various heights.
• With height determined, loosely bolt Assembly to Frame Brackets using (6)
½" x 1 ½" Hex Head Bolts, ½" Hex Head Nuts, ½" Flat Washers, and ½" Lock
Washers
3. FINAL SQUARING:
• With step square at desired height, tighten all hardware.
FLIP DOWN REAR STEP OPTION
Power drill
Drill bit set
PART #
GSM33050
GSM33055
GSM31012
GSM31030
GSM30020
GSM30011
GSM30046
Advertisement
Table of Contents
Related Manuals for Havis-Shields Flip Down Rear Step Option KK-ST-FLIP
Summary of Contents for Havis-Shields Flip Down Rear Step Option KK-ST-FLIP
- Page 1 INSTALL INSTRUCTIONS KK-ST-FLIP FLIP DOWN REAR STEP OPTION (For Rear Permanent Mount Step order with KK-x-ST-RP) TOOLS REQUIRED: Ratcheting wrench Standard socket set Open-end wrench set HARDWARE: QTY DESCRIPTION ½” x 1 ½” Hex head bolt ½” x 3 ½” Hex head bolt ½”...
- Page 2 • Start with the Frame Brackets and then check for square again. • Proceed to tighten Support Channels to Frame Brackets then Frame Brackets to Step Plate. Note: There are numerous holes in the step brackets for other Vehicle applications. IF FLIP PORTION OF STEP WAS ODERED SEPARATELY USE THE FOLLOWING: INSTALLATION: 1.
- Page 3 KK-ST-FLIP-INST-6-07...
Need help?
Do you have a question about the Flip Down Rear Step Option KK-ST-FLIP and is the answer not in the manual?
Questions and answers