Sirius XM RAdio ONYX EZ User Manual page 42

Vehicle Installation
vi. Start Using is highlighted. Press the Select button.
vii. The FM channel you selected will be confirmed on the display
screen. Onyx EZ
9. You should hear XM channel 1 through your vehicle's FM radio. If you
are satisfied with the sound quality, the installation is complete. You are
now ready to activate your Onyx EZ.
10. Go back to "Step 2: Install the Dash or Vent Mount" on page 12
and finish installing the Dash or Vent Mount. Then the installation is
complete.
11. If the selected FM channel doesn't work well for you, work down the list
of FM channels until you find one with which you are satisfied. Each time,
you will need to tune your vehicle's FM radio to the FM channel and then
set your Onyx EZ to transmit on the same FM channel (steps 7 & 8).
If the signal reception is good, showing at least two bars in the lower left
corner of the display, but there is no XM audio, verify that both Onyx EZ
and your vehicle's FM radio are tuned to the same FM channel (steps 7 &
8). Also ensure the chosen FM channel is a suitable one to use in your area
(step 5). Verify that nothing is plugged into the AUDIO connector on the
PowerConnect Vehicle Dock. Refer to "Troubleshooting" on page 79 for
additional help.
Option 4: FM Direct Adapter (FMDA) Installation
The FMDA needs to be installed by a professional installer. Professional
installation can help improve your Radio's reception and significantly
reduce the visibility of wires. To learn more, check with the retailer where
you bought your Radio, or go to www.siriusxm.com/accessories.
42
will tune to the FM channel.