Sirius XM RAdio ONYX EZ User Manual page 38

Vehicle Installation
display screen.
7. Ensure Onyx EZ is tuned to channel
1, the XM Preview channel. Upon
power up, Onyx EZ should tune to
channel 1 by default, when it's not yet
activated. If it's not on channel 1, refer
to "Listening to Satellite Radio" on
page 48 to learn about how to tune
a channel.
8. Turn on your vehicle's stereo system.
Set it to play from the auxiliary input
source. You should hear XM channel 1
through your vehicle's stereo system.
You are now ready to activate your
Onyx EZ.
9. Go back to "Step 2: Install the Dash or
Vent Mount" on page 12 and finish
installing the Dash or Vent Mount.
Then the installation is complete.
10. The audio level output of Onyx EZ can be increased or decreased as
necessary to match the audio levels of other sources in your vehicle.
Refer to "Set Audio Level" on page 68.
If the signal reception is good, showing at least two bars in the lower left
corner of the display, but there is no XM audio, be sure the vehicle's stereo
system is set to the cassette source (step 4). Also be sure that the audio
level is set high enough to be heard (step 5). Refer to "Troubleshooting" on
page 79 for additional help.
38
1
866-635-2349
siriusxm.com
Signal Indicator
SATELLITE
-
TERRESTRIAL
-
XM Preview
+
+