Schwinn 213 Parts List, Full Size Hardware Chart, Product Illustration, Assembly Instructions page 12

Attach Front Stabilizer Tube and Pedals to Main Unit
Assembly Hardware Required:
Step 9: Attach FRONT STABILIZER TUBE (#11) to the MAIN UNIT (#13) with 2
FLAT HEAD SCREWS (#12). Tighten Bolts with provided wrench.
Step 10: Attach RIGHT PEDAL (#14) to the right crank arm on the MAIN UNIT
(#31). Thread the pedal onto the crank arm and then tighten with pedal wrench.
Attach LEFT PEDAL (#14) to the left crank arm on the MAIN UNIT (#13). Thread
the pedal onto the crank arm and then tighten with pedal wrench. Note: There is a
right pedal and a left pedal, marked by R and L. The threading on the left pedal
is reversed from the right pedal. Counterclockwise rotation tightens while
Clockwise rotation loosens on the left pedal. To avoid stripping of the threads be
careful to use the proper pedal.
Attach PEDAL STRAPS (#18) to each PEDAL (#14). Again, each strap is labeled
with an R or an L corresponding to the right and left pedal straps.
Assembly Stage #5
(2) Flat Head Screw (item #12)