Maintenance; General; Cleaning; Display Light Bulb Replacement - Hatco MACHO NACHO FDW-1-MN Series Installation And Operating Manual

MAINTENANCE

GENERAL

Hatco Macho Nacho Chip Warmers are designed
™
for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch
off at the fuse disconnect switch/circuit breaker
or unplug the unit from the power source
and allow to cool completely before performing
any maintenance or cleaning.

CLEANING

To preserve the bright finish of the unit, it is
recommended that the exterior and interior metal
surfaces be wiped daily with a damp cloth. Stubborn
stains may be removed with a good stainless steel
cleaner or a non-abrasive cleaner.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it susceptible
to soil accumulation.
Clean the glass using a common glass cleaner.
NOTE: For better access to the inside of the unit, the
rear door panel assembly can be removed by loosening
the thumbscrews on each side of the door panel
assembly and lifting the assembly up and off. Be sure to
tighten thumbscrews securely when installing the door
panel assembly. See Figure 8.

DISPLAY LIGHT BULB REPLACEMENT

The display light is an incandescent light bulb which
illuminates the warming area. The bulb has a special
coating to guard against injury and food contamination
in the event of breakage.
1. To replace a light bulb, disconnect the power supply
and wait until the unit has cooled.
2. Bulbs have a threaded base. Unscrew the light bulb
from the unit and replace it with a new specially
coated incandescent bulb.
NOTE: Hatco shatter-resistant light bulbs meet N.S.F.
standards for food holding and display areas. For 100
and 120 volt applications, use Hatco part
#02.30.043.00. For 220 or 240 volt applications, use
Hatco part #02.30.058.00.
Form No. MNM-0702
Thumbscrews
(Two on each side)
Figure 8. Removing Door Panel Assembly
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents
and Genuine Hatco Parts when service is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure
to use Hatco Replacement Parts may subject
operators of the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.
6
WARNING
WARNING
WARNING
WARNING