ALL MODELS
CAUTION
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
1. Plug warmer into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. See SPECIFICATIONS for details.
2. Turn the Power Switch to the ON position. See
Figures 6 & 7.
3. Turn the Temperature Control to the desired
temperature setting.
4. Allow unit 15-20 minutes to reach operating
temperature.
5. Open top door and fill unit with chips.
6. At the end of the day or shift, turn unit off and allow
to cool down. Clean as required.
Power Switch
Temperature Control
Figure 6. Control Panel FDW-1-MN
Temperature Gauge
Power Switch
Figure 7. Control Panel FST-1-MN
5
OPERATION
Temperature Gauge
FLAV-R-FRESH
FLAV-R-SAVOR
Temperature Control
Form No. MNM-0702