Important Safety Instructions - Hatco MACHO NACHO FDW-1-MN Series Installation And Operating Manual

IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.
WARNINGS
Plug unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size, and install the proper
electrical outlet.
To avoid any injury, turn the power switch
off at the fuse disconnect switch/circuit breaker
or unplug the unit from the power source
and allow to cool completely before performing
any maintenance or cleaning.
For safe and proper operation, the unit must be
located at a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion
could occur.
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
To prevent any injury, discontinue use if power
cord is frayed or worn.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966
or International fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury
to personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when service
is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco
Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in
electrical shock or burn.

IMPORTANT SAFETY INSTRUCTIONS

Locate the unit at the proper counter height,
in an area that is convenient for use. The location
should be level to prevent the unit or its contents
from accidentally falling, and strong enough
to support the weight of the unit
and food displayed.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the
ambient air temperature is a minimum of 70°F
(21°C).
To prevent injury or damage the unit must be
transported in the upright position. If laid on its
side, all glass surfaces must be secured with tape.
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it susceptible
to soil accumulation.
1
CAUTIONS
CAUTIONS
Form No. MNM-0702