Maintenance; General; Daily Cleaning - Hatco Palletti IWRM Series Installation And Operating Manual

General

Hatco Induction Warmers are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power, unplug power cord, and allow unit to
cool before performing any cleaning, adjustments, or

maintenance.

• DO NOT submerge or saturate with water. Do not allow
liquids to spill into unit. Unit is not waterproof. Do not
operate if unit has been submerged or saturated with
water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. Cord must be replaced by an Authorized Hatco
Service Agent or a person with similar qualifications.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• ELECTRIC SHOCK HAZARD: Use only Genuine Hatco
Replacement Parts when service is required. Failure
to use Genuine Hatco Replacement Parts will void all
warranties and may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical
shock or burn. Genuine Hatco Replacement Parts
are specified to operate safely in the environments
in which they are used. Some after-market or generic
replacement parts do not have the characteristics that
will allow them to operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
+1-414-671-6350.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces.
Wipe up all spills and splashes immediately. Make sure unit
is dry before using. Do not allow liquid to run into air inlet
filter on bottom of unit.
Form No. IWRMCEM-0321
CAUTION

Daily Cleaning

To maintain performance and preserve the finish of the Induction
Warmer, clean the unit daily. Make sure to use only wipes, pads,
and cleaners designed specifically for cleaning ceramic glass
surfaces.
1. Turn off and unplug the unit. Allow the unit to cool.
2. Remove and wash all food pans.
3. Clean the glass surface using an appropriate cleaning
wipe, damp paper towel, or damp cloth.
• For tough stains and metal marks, use a drop of ceramic
glass cleaner and paper towel.
• For water and scale marks, use a few drops of white
vinegar and paper towel.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
5. Clean the metal surfaces using a clean, soft cloth and mild
detergent.
6. Wipe dry all metal surfaces using a dry, clean, soft cloth.
13
MAINTENANCE
NOTICE