Installation - Zanussi ZOD580 User Manual

Information for appliances with metal fronts:
Due to the appliance's cool front, when the door is
opened during or shortly after baking or roasting, there
may be condensation of the inner glass panel for a short
while.
Please carry out the following checks on your appliance
before calling a Service Engineer. It may be that the prob-
Problem
The grill, ovens and timer do not work. Check that the appliance has been wired in to the appliance supply and is
The grill does not work or cuts out after
being used for a long period of time.
The indicator neons are not working
correctly.
The oven is not cooking evenly.
The oven light fails to illuminate.
The oven fan is noisy.
The oven temperature is too high or too
low.

Installation

• The set-up of the electrical installation is arranged so
that the appliance can be isolated from the mains with
a minimum 3 mm all-pole contact separation.
Suitable isolation devices include, for example, circuit
breakers, fuses (screw type fuses are to be removed
from the holder), RCDs and contactors.
• Anti-shock protection must be provided by the instal-
lation.
20
lem is a simple one which you can solve yourself without
the expense of a service call.
In-guarantee customers should make sure that the checks
have been made as the engineer will make a charge if the
fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for in-
guarantee service calls.
switched on at the wall.
Check that the main appliance fuse is working.
If you have checked the above: Allow the appliance to cool for a couple of
hours. The appliance should now be working normally.
Ensure the cooling fan is running when the grill is on. If the cooling fan
fails, the grill will not operate correctly. Contact your local service force
centre.
Leave the grill door open and allow the grill to cool. After a couple of hours
check that the grill works as normal
Check that you have selected only the function you require. Ensure all other
controls are in the off position.
Check that the appliance is correctly installed and is level.
Check that the recommended temperatures and shelf positions are being
used.
The oven light bulb may need replacing.
Check that the oven is level.
Check that the shelves and bakeware are not vibrating in contact with the
oven back panel.
Check that the recommended temperatures and shelf positions are being
used. Be prepared to adjust the temperature up or down slightly to achieve
the results you want.
• The built-in unit must meet the stability requirements
of DIN 68930.
• Built-in cookers and cooking surfaces are equipped
with special attachment systems. For safety reasons,
they must only be combined with appliances from the
same manufacturer.
The use of heat protection strips is prohibited for cookers
and ovens with Pyrolytic Cleaning, if the recess has a rear
wall and closed ground-level compartment.
Possible Solution