Zanussi ZOD580 User Manual page 16

Accessories
• Clean and dry the oven accessories (shelf, tray, roast-
ing pan, etc.) after each use. Soak the items to make
cleaning easier.
Catalytic cavity cleaning
Warning! You must not wipe out the cavity side
walls. It will damage the catalytic surface.
1. Remove all slide-in parts from the oven.
2. Wipe the floor of the oven clean with warm washing-
up solution and dry.
3. Set the oven with max temp. of 275˚C for 30 min (use
Conventional Cooking or Thermaflow® function).
4. Oven will switch off after one hour.
5. Wipe away any remaining a damp from the floor with
soft sponge.
Warning! Before you wipe away wait until the cavity
is cool.
Warning!
Do not use oven spray or abrasive cleaning agents. Do
not use soap or other cleansing agents. The catalytic
coating may otherwise be damaged.
After long periods of use, the catalytic coating may
become slightly discoloured. This has no effect on
the catalytic properties.
Side rails
The side rails on the right and left-hand side of the oven
interior can be removed for the purpose of cleaning the
side walls.
Removing the side rails
Pull the rails away from the
oven wall at the front
16
(selected models only)
Unhook them at the back
Replace the side rails
Important! Important The rounded ends of the guide bars
must point to the front.
To install, first (1) and then .
1
2
Insert the rails in the holes
at the back
Oven back lamp (for selected models only)
Warning! Risk of electric shock! Before replacing
the oven light bulb:
– Switch oven off.
– Unscrew the fuse from the fuse box or switch fuse off.
To protect the oven light bulb and the glass cover,
lay a cloth on the floor of the oven.
Replacing the oven light bulb/Cleaning the glass cover
1. Take off the glass cover by turning it anticlockwise
and clean it.
2. If necessary:
replace with a 40 Watt, 230V, 300°C heat-resistant
oven light bulb .
3. Refit the glass cover.
Lower into position at the
front and press them at the
back