Walk Test (User Type 2.5 And Above); Purpose; Selecting Walk Test; All Zones - Honeywell Galaxy 3-144 User Manual

Walk Test (User Type 2.5 and Above)

PIN + ent
0 = OMIT ZONES
[ent] to Select
6
6 = Walk Test
ent to select
ent
1=TEST ALL ZONES

2=SELECTED ZONES

1
WALK TEST ACTIVE
ESC to abort
NO ENTRIES
2
1001 FINAL
#=TEST ENT=START
>A
1002 EXIT
#=TEST ENT=START
#
1002 EXIT
TEST ENT=START
ent

Purpose

The Walk Test option provides a method of testing the zones to
ensure that they are operating correctly. There are two options
available:
1. All zones can be tested
2. Selected zones can be tested
In both cases the sounder indicates an open zone. The test is recorded in
the log. Wire-free zones also show the received signal strength as a
percentage

Selecting Walk Test

Enter the QUICK MENU. Press the key 6 followed by the ent key.
When Walk Test is selected, Test All Zones or Selected Zones
displays.

All Zones

Choosing All Zones (press key 1) starts the test immediately. No
selection is necessary as all valid zones are included in the test. The
sounder operates whenever a zone is opened and stops when all zones
are closed.
Note: The Test All Zones option only tests zones which can
be omitted from the system.
Selected Zones
Choosing the Selected Zones option by pressing key 2 displays the
first zone on the system. Each zone is displayed in turn by using the >A
or <B keys. When the zone to be included in the test is displayed, press
the # key. Other zones can be included in the test in the same manner.
When all of the required zones have been selected, press the ent key to
start the Walk Test.
Note: The Selected Zones option includes non-omittable
zones.

Ending Walk Test

To abort the walk test option press the esc key, otherwise the walk test
option remains active for 20 minutes after the last key press.
15