Alarm And Help Messages; Alarm In Progress; Pa Reset Required; Manager Reset Required - Honeywell Galaxy 3-144 User Manual

ALARM AND HELP MESSAGES

ALARM IN
PROGRESS
PA
RESET REQUIRED
CALL MANAGER
RESET REQUIRED
CALL ENGINEER
RESET REQUIRED

NO ENTRIES

INVALID
OPTION

Invalid code

Option not
available
CALL ALARM CO.
QUOTE CODE XXXXX
NO MODULE ADDED
ESC TO CONTINUE

Alarm In Progress

The system is currently in alarm condition and must be cancelled by a valid PIN or
keyswitch operation.

Pa Reset Required

After a PA (Personal Attack) zone has been activated, the system has to be reset by a
high level code (such as a manager or engineer depending on the reset level setting).

Manager Reset Required

Following an alarm activation, the system requires to be reset by a manager level code.
This message is displayed when a tamper alarm occurs.

Engineer Reset Required

The system has been programmed for engineer reset following an alarm activation. The
engineer must be called to reset the system before the user can set the alarm.Tamper
alarms usually require an engineer to visit the site to check all modules on the system.
No Entries
This message appears if a user attempts to view or inspect the log and there is nothing in
the log to be viewed or when the omit option is selected and there are no omittable
zones on the system.

Invalid Selection

The option selected or value entered is illegal or out of range.
Invalid Code
The code entered is not a valid code registered in the system memory.
Option Not Available
This option is provided by the engineer, where it is specifically required. Attempting to
select an option when it has not been provided results in the display of

Technistore Reset

Call the Alarm Monitoring Station and quote the five digit number displayed. Enter the
number quoted by the monitoring station to reset the system.

No Modules Added

When exiting Engineer Mode the panel does not detect the change in the number of
modules. Press esc to continue.
34