Menu Options
Menu Options
The full menu structure for the panel can only be accessed while in Engineer program mode. The structure is
shown in the following table:
Enter Engineer program mode. Press
0 = Walk Test
The walk test function allows each detector to be checked in order to verify that they are functioning correctly.
A tone is generated as each zone is activated (opened).
LCD keypad
•
Press
for menu Walk Test.
•
Press
or [0]. Zones 1-8 have a zero (0)below
each number.
•
When a zone is sucsessfully tested, number 1replaces the 0.
Zones are added to list as each one is activated.
•
Press
to leave the menu or
LED keypad
•
Press [0] for menu Walk Test.
•
Press
. Zones 1-8 are off
•
When a zone is sucsessfully tested, the LED is on.
Zones are added to list as each one is activated.
•
The Tamper LED comes on when tested.
•
Press
to leave the menu or
the Walk Test.
MENU OPTIONS
0 = Walk Test
6 = Zone Names
1 = Alarm Test
7 = Timers
2 = Test Outputs
8 = Codes
3 = System Flags
C = View Event Log
4 = Time and Date
O = Omit Allow & Double
5 = Language
P = Programmes
Table 2. Menu Options
[9] [9] [9] [9].
to restart the Walk Test.
to restart
18
Accenta/Optima Engineer's Manual
Knock
0>Walk Test
12345678
00000000
0>Walk Test
or [0]
TP
00
1
2
3
4
5
6
7
4
1
2
3
5
6
7
8
8