Automatically Storing Stations Into Memory. (The Automatic Preset Mode: Asm); Manually Storing Stations Into Memory; Preset Station Scan - Eclipse CD5030 Owner's Manual

Automatically storing stations
into memory. (The automatic
preset mode: ASM)
Hold down the [ ] button (for more
1
than one second) until the beep
sounds.
The automatic preset mode starts.
"ASM ON" will appear on the display,
and stations are automatically entered
in memory under buttons [1] to [6].
These buttons are called the preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is shown on the display.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
CAUTION
1 2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in the
memory again.
How to operate the tuner
Manually storing stations into
memory
Store a station to a preset button.
Tune to a station frequency you
1
wish to store by pressing the [<]
or [>] button.
Select any button, from [1] to [6],
2
and press it for more than two
seconds.
The selected station is stored in the
preset button.
Repeat the above procedure to store
additional stations one at a time in
buttons [1] to [6], and store them in
memory.
CAUTION
1 2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in
memory again.

Preset station scan

This function enables reception of all the stations
in the preset buttons for five seconds each.
Hold down the [ ] button for more
1
than 1 second.
"P SCAN" will appear on the display,
and stations stored under preset
buttons [1] through [6] will be played
for five seconds each.
When your desired station is
2
displayed, press the [ ] button
again.
The main unit will stay tuned to the
desired station.
VII
41