Loading Single Sheets (Top Feed) - OKIDATA ML320 User Manual

Loading Single Sheets (Top Feed)

Use the single-sheet path for letterhead stationary, memos,
and individual envelopes.
Note: If you have continuous-form paper in the path, press
to remove it before loading single sheets.
PARK
1. Make sure the printer is on and deselected (SEL light
off).
2. Place the paper lever in the position marked "TOP."
3. Open the carriage cover and lift the paper separator to
the single-sheet position.
E-8 Section 1
4. Make sure the wire feed
guide ( ) is secured
in the sheet guide.
5. Adjust the paper feed guides ( ) for the width of the
paper and place a sheet of paper in the separator. The
paper will feed into the printer.
Important!
If the paper does not feed
in, remove it. Check the
paper lever position. Make
sure the ALARM light is
on: if it is flashing, hold the
SHIFT key and press the
CHARACTER PITCH
(RESET) key. Reload the
sheet of paper.
Note: The standard setting for the Top of Form (where the
printing begins) is 1-inch down from the top of the
page. To change the setting, see page 9.